Safety and Education
|
EMERGENCY SIPDE Riders are to be aware of what is going on around them at all times. A way to improve your riding is this 5-step process to help improve making appropriate judgments and applying them correctly for different situations. Scan Identify Predict Decide Execute SCAN Search ahead, at sides and behind to avoid potential hazards before they arise. These hazards could be oncoming traffic turning left in front of you, traffic approaching from left, right or behind and hazardous road conditions. Focus on finding potential escape routes around intersections, shopping areas, schools and construction zones. Be alert in areas of limited visibility. Visually 'busy' areas can hide you from others.
IDENTIFY Locate possible hazards: any vehicle that may move into your path and
possibly cause an accident Anticipate how the hazard may affect you. Predict where a collision may occur. Completing "What if ...?" phrase depends on individual's knowledge and experience in estimating the results of contacting or avoiding the hazard. DECIDE Determine what you need to do based on your predication. Your course of action depends on your previous searching. You want to eliminate or reduce the potential hazard. Decide when, how and where to take action. Your continual decision making tasks must stay sharp to deal with constantly changing traffic conditions.
EXECUTE Carry out your decision. To minimize harm from any hazard, communicate your presence with lights and/or horn while adjustingyour speed and position and/or direction.
Apply the old adage 'one step at a time' to handle two or more hazards. Adjust speed to permit two hazards to separate and then deal with them individually as single hazards. Decision making becomes more complex with three or more hazards. Weigh the consequences of each and give consideration to them individually, if possible. In potential high risk areas, cover the clutch and both brakes to reduce the time you need to react.
Keep alert, be friendly and enjoy riding the roads.
___________________________________________________
GROUP RIDING A few general rules to follow:
* Riding in groups of many motorcycles can be confusing for both the group and other traffic. If there are too many people, break up into smaller groups. Group size should not consist of over 7 bikes unless involved in a parade type event. When there is the need to split up into smaller groups they are to be separated by at least 5 minutes of each other on the road. Use common sense to allow for traffic to flow in a normal fashion.
* Ride in a staggered formation. The first bike will be on the left side of the lane, the second bike on the right side and so on. Not side by side. This formation to be maintained unless conditions, (such as narrow roads, numerous curves, no shoulders or pull-offs, etc and/or any other conditions that is deemed unsafe for formation riding), warrant otherwise.
* Keep a two-second interval (minimum) from the motorcycle that is in front of you. If riding behind a trike, an increase interval (3-4 seconds) should be established, since a trike can stop quicker than a regular two-wheel motorcycle. You do not want to end up in the trike's trunk compartment.
* At traffic lights and stop signs wait in pairs.
* When passing other vehicles,
do individually and safely. Not in groups or pairs. The group leader
(front door) and the Shotgun/Tail-gunner rider (Back Door) are to work
together when vehicle passing, lane changes, turns & etc are required.
No bike should pull out of existing formation until instructed by group
leader, unless a circumstance un-expectedly occurs that must be avoided
to prevent an accident.
GROUP LEADER & BACK DOOR RIDER RESPONSIBILITIES
An experienced rider should be at each position and both equipped with CB radios for communication.
The Group Leader has the responsibility that all members of the formation know the destination and route to be taken. If the group becomes separated, a regrouping point is to be determined as quickly as possible by the Group Leader.
Lane changes are to be accomplished by the Group Leader instructing the Back Door Rider to appropriate the new lane when available. Once the lane is clear up to the Group Leader, the Back Door will inform the Leader that the lane is secure. The Leader will then use his turn signal, make a head check, look in mirror and change lanes. Each following bike is to use same procedure.
The Back Door Rider has the responsibility to keep the Group Leader informed as to the formations status in all situations. Also, he should attempt to keep the formation alert to any impending danger such as rapidly approaching vehicles, semis, reckless drivers and so forth.
MASTER TOUR RIDER |